Haier HBF05E Manual De Usuario

Cause 2
Improper drawing of beer into the glass.
Correction
• Open the faucet quickly and completely.
• Proper foam should be a tight creamy head.  The collar on the average glass

should be 3/4" to 1" high.  Beer drawn without head has the appearance of
being flat.

Cause 3
Not enough pressure.
Correction
• Increase the pressure if beer runs too slowly.  The correct flow should fill a 10oz.

glass in 4 seconds. (Approx. 8oz. of liquid)

• Check the pressure source to determine whether there are obstructions in the air

line.

• Replace a sluggish air source or the CO

2

regulator and gauge.

• The tank pressure must always be higher than the pressure used on the keg.
• Always apply pressure to the keg before drawing beer.

Beer Condition: Loose Foam
Large soap-like bubbles that settle quickly.

Cause 1
This is generally the same as the Flat Beer condition.  See the Flat Beer
causes above.

Beer Condition: Off-Taste Beer
Often bitter and bitey; sometimes completely lacking in flavor and zest. May
also have an oily or foul odor, which carries an unpleasant taste.

Cause 1
Improper cleaning of the tap.
Correction
• Brush and clean the tap properly. It should be scoured using a detergent, then

rinsed clean.

Cause 2
Contaminated air line.
Correction
• Air line should be examined.  If contaminated, it should be replaced.