Helio PM5500 Manual De Usuario

3

•  Only trained, qualified medical personnel under the direct supervision of a 

licensed physician should operate the 

 Blender.

•  Use this 

 Blender only for its Intended Use as described in this 

manual.

•  Confirm prescribed dose before administering to patient. Monitor on a 

frequent basis. Continuous Monitoring with an alarmed Oxygen Monitor 

/ Analyzer is recommended.

•  The 

 Blender shall be serviced by a qualified service technician.

•  Always follow ANSI and CGA standards for Medical Gas Products, 

Flowmeters and Oxygen Handling. 

•  The clinician must verify the Heliox tank concentration prior to utilizing 

the Blender.

•  An alarmed Oxygen Monitor / Analyzer must be used to verify oxygen 

concentration.

•  Accuracy of oxygen concentration will be affected if bleed is not activated 

at flow settings below 15 lpm for the High Flow Blender, and 3 lpm for 

the Low Flow Blender.

•  dO NOT obstruct the alarm.

•  dO NOT use Blender when alarm is sounding.

•  dO NOT use oil in or around the Blender.

•  dO NOT occlude or obstruct the bleed port on the auxiliary outlet of 

the Blender.

•  dO NOT use near any type of flame or flammable/explosive 

substances, vapors or atmosphere.

•  Oxygen Concentration dial does not rotate 360 degrees. Rotating the 

dial beyond the endpoint settings will damage the Blender.

•  Turn off gas supplies when

 Blender is not in use.

•  Store the

 Blender in a clean, dry area when not in use.

•  The

 Blender contains magnetic, ferrous material that may

affect the results of an MRI.

•  Ensure all connections are tight and leak free.

•  Avoid excessive pressure surges greater than 100 psi (6.9 bar) when

pressuring the Blender inlets.

•  DO NOT steam autoclave.
•  DO NOT immerse

 Blender into any liquid.

•  DO NOT gas sterilize with (EtO) Ethylene Oxide.

•  DO NOT use if dirt or contaminants are present on or around the

Blender or connecting devices.

•  DO NOT smoke in an area where oxygen is being administered.

•  DO NOT clean with aromatic hydrocarbons.
•  Inlet pressure of Device used in conjunction with the

Blender must

match inlet pressure of

F

Blender.