Jura Capresso 13623 Manual De Usuario
54
7 Troubleshooting
7 Troubleshooting
Problem
Cause/Result
Action
Insufficient foam is
produced when the milk
is frothed, or milk sprays
from the dual spout.
produced when the milk
is frothed, or milk sprays
from the dual spout.
The dual spout is dirty.
T Rinse and clean the dual spout (see
Chapter 5 ‘Maintenance – Cleaning
the milk system’).
Chapter 5 ‘Maintenance – Cleaning
the milk system’).
Coffee only comes out in
drips when it is being
prepared.
drips when it is being
prepared.
Coffee or ground coffee has
been ground too finely and
is blocking the system. The
same filter cartridge may
have been used several
times or the water hardness
set incorrectly in the
programming mode.
been ground too finely and
is blocking the system. The
same filter cartridge may
have been used several
times or the water hardness
set incorrectly in the
programming mode.
T Put the grinder on a coarser setting
or use coarser ground coffee (see
Chapter 4 ‘Permanent settings in
programming mode – Setting the
consistency of grind’).
T Perform descaling (see Chapter 5
‘Maintenance – Descaling the
machine ’).
or use coarser ground coffee (see
Chapter 4 ‘Permanent settings in
programming mode – Setting the
consistency of grind’).
T Perform descaling (see Chapter 5
‘Maintenance – Descaling the
machine ’).
‘Fill bean container.’
is not displayed although
the bean container is
empty.
the bean container is
empty.
The bean monitor is dirty.
T Clean the bean container (see
Chapter 5 ‘Maintenance – Cleaning
the bean container’).
Chapter 5 ‘Maintenance – Cleaning
the bean container’).
Preparation stops,
‘Fill bean container.’
is briefly displayed
although the bean
container has been filled.
although the bean
container has been filled.
The sliding catch for the
bean container has not been
pulled out or has not been
pulled out completely.
bean container has not been
pulled out or has not been
pulled out completely.
T Open the service cover on the back
of the machine and pull the sliding
catch all the way out (see Chapter 5
‘Maintenance – Cleaning the bean
container’).
of the machine and pull the sliding
catch all the way out (see Chapter 5
‘Maintenance – Cleaning the bean
container’).
‘Empty drip tray.’
is always displayed.
The metal contacts of the
drip tray are dirty or wet.
drip tray are dirty or wet.
T Clean and dry the metal contacts on
the back of the drip tray.
the back of the drip tray.
‘Fill water tank.’
is displayed although the
water tank is full.
water tank is full.
The water tank float is
trapped.
trapped.
T Descale the water tank (see
Chapter 5 ‘Maintenance – Descaling
the water tank’).
Chapter 5 ‘Maintenance – Descaling
the water tank’).
‘Error 2’
is displayed.
If the machine was exposed
to the cold for a long period
of time, heating is disabled
for safety reasons.
to the cold for a long period
of time, heating is disabled
for safety reasons.
T Warm the machine at room
temperature.
temperature.