Bunn System III Manual De Usuario

Page 32

Location:

The  start switch is  located in front of hood  to the

left of the ON/OFF switch.

Test Procedure:
1. Disconnect the brewer from the power source and

remove the wires from both terminals of the switch.

2. Check for continuity across the two terminals on

the switch when it is held in the lower position.
Continuity must not be present across these ter-
minals in the upper position.

If continuity is present as described, reconnect the
wires, the switch is operating properly.
If continuity is not present as described, replace the
switch.

P1104

P1108

Removal and Replacement:
1. Remove all wires from the switch terminals.
2. Compress the clips inside the hood and gently

push the switch through the opening.

3. Push the new switch into the opening and spread

the clips to hold the switch in the hood.

4. Refer to FIG. 26 when reconnecting the wires.

FIG. 25 START SWITCH

WHI/ORN to Timer TL3 -
(Electro/Mechanical) or
BLK to DBC J3-6

WHI/YEL to Timer TL5 -
(Electro/Mechanical) or
BLU to DBC J3-21

FIG. 26 START SWITCH TERMINALS

27362  092900