Bunn SNG0033000 Manual De Usuario

Descargar
Página de 38
Page 15
SET NEW RECIPES (cont.)
PROGRAMMING THE BREWER (cont.)
SET NEW RECIPE:
Using a RECIPE CARD to load coffee names and 
brew settings into the Single/Dual SH DBC with 
Smart Funnel:
 
The G9-2T DBC or MHG's memory contains certain 
coffee names. If the operator uses a coffee name that is 
not already stored in the grinder's memory, a RECIPE 
CARD can be obtained from the factory. The RECIPE 
CARD would include all the information needed to set 
up that particular coffee name. The information from 
the RECIPE CARD is loaded into the grinder's memory, 
then into the brewer's memory by holding the chip 
area up to the equipment's sensing coil. This informa-
tion can include the coffee name, BREW VOLUMES, 
BYPASS PERCENTAGES, PULSE BREW TIMES, and 
DRIP-OUT TIMES  for that particular coffee NAME. 
These can all be loaded in seconds.
  Contact Bunn-O-Matic Corporation for the avail-
ability of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder 
are printed on the RECIPE CARD, along with the coffee 
name that is being programmed.
Procedure to program the coffee name:
1.  Remove the funnels (if present) from the funnel 
rails (both sides on DUAL brewers).
2.  Position the RECIPE CARD vertically, so that the 
top end of the chip is beneath the funnel sensing 
coil (left side on DUAL brewers).
3.  After a short pause the display will read CARD CON-
TAINS RECIPE FOR then will change to (COFFEE 
NAME) SHOW QUIT SAVE. All brewing parameters 
for that coffee name are now transferred from the 
CARD to the brewer.
4.  To show (view) this information, press and release 
SHOW. The display will scroll through all of the 
brew settings for all three batch sizes. The display 
will then return to CARD CONTAINS RECIPE FOR 
then will change to (COFFEE NAME) SHOW QUIT 
SAVE.
5.  If all brew settings are correct, press SAVE. The 
display will read (COFFEE NAME) SETUP COM-
PLETE. All brew settings for that name are now 
stored in the brewer's memory.
6.  If the brewing information is not correct, or it is 
desired to exit the setup before the settings are 
loaded into the brewer's memory, press QUIT. The 
display will read (COFFEE NAME) NOT SAVED. The 
display will then return to the MAIN SCREEN.
POSITION CARD UNDER THE 
SENSOR COIL
(left side on DUAL brewers)
READY TO BREW
     WATER TEMP: 200° 
CARD CONTAINS
RECIPE FOR
(COFFEE NAME)
SHOW  QUIT  SAVE
(COFFEE NAME)
SETUP COMPLETE
(COFFEE NAME)
NOT SAVED
SCROLLS THROUGH ALL 
OF THE BREW SETTINGS 
FOR THE THREE BATCH 
SIZES FOR THAT COFFEE 
NAME
41341 080108