Bunn SNG0033000 Manual De Usuario

Page 28

  This function allows the operator to adjust the 

sensitivity of the refill circuit. This is mainly a trouble-

shooting feature. Water in different geographical loca-

tions can have different conductivities. By adjusting 

the sensitivity of the refill circuit, this will allow the 

brewer to operate under various water conditions.

NOTE: Make sure the water in the tank is touching 

the refill probe.

1.  Press and hold upper right hidden switch until the 

display reads UNITS. Release switch.  Continue to 

press and release switch until the display reads 

REFILL and shows a number on both sides of the 

word.

2.  To adjust the threshold setting, press (-) to de-

crease, or (+) to increase the setting.

NOTE: Always make sure that the number on the right 

is larger than the number on the left when water is in 

contact with the refill probe in the tank.

3.  When finished, press and release DONE. This 

saves the new setting and advances to the next 

function screen:

  SPR

Y OZ/M (SINGLE brewers)

L SPRY OZ/M (DUAL brewers). Another alternative 

is to press and release the ON/OFF switch (either on 

DUAL brewers) located on the front switch panel 

to exit REFILL and return to the MAIN SCREEN.

1.  Press and hold upper right hidden switch until the 

display reads UNITS. Release switch.  Continue to 

press and release switch until the display reads 

SET READY.

2.  To adjust the ready temperature, press the (-) 

button to decrease, or (+) to increase the ready 

temperature.

3.  When finished, press and release DONE to save 

the new setting, exit the SET READY function and 

advance to the next function screen, REFILL. 

Another alternative is to press and release the 

ON/OFF switch (either on DUAL brewers) located 

on the front switch panel to exit the SET READY 

function and return to the MAIN SCREEN.

2.  To adjust the brew temperature, press (-) to de-

crease or (+) to increase the brew temperature.

3.  When finished, press and release DONE to save 

the new setting, exit the SET TEMP function and 

advance to the next function screen,  SET READY. 

Another alternative is to press and release  the ON/

OFF switch (either on DUAL brewers) located on 

the front switch panel to exit the SET TEMP func-

tion and return to the MAIN SCREEN.

 

This function allows the operator to set the mini-

mum temperature allowable to start a brew cycle. The 

range can be from 185˚F (85˚C) to within 2˚F (-1.7°C) 

of the SET TEMP. The water must be at the SET READY 

temperature or higher for the display to indicate READY 

TO BREW. If brew lockout is enabled, the brewing pro-

cess will not start below this READY temperature.

NOTE: The upper limit for SET READY temperature 

is 2˚F (-1.7°C) less than the water temperature (SET 

TEMP) setting.

SET READY: XXX°

 (-)  DONE  (+)

XXX REFILL -> XXX

 (-)  DONE  (+)

41341 080108