Bunn Single SH Manual De Usuario
Page 15
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE
Using a TAG CARD to load coffee names and brew
settings into the SINGLE
Using a TAG CARD to load coffee names and brew
settings into the SINGLE
TM
SH DBC with Smart
Funnel
TM
:
The G92T DBC's memory contains certain coffee
names. If the operator uses a coffee name that is not
already stored in the grinder's memory, a TAG CARD
can be obtained from the factory. The TAG CARD
would include all the information needed to set up that
particular coffee name. The information from the TAG
CARD is loaded into the grinder's memory, then into
the brewer's memory by holding the tag up to the
equipment's sensing coil. This information can in-
clude the coffee name, BREW VOLUMES, BYPASS
PERCENTAGES, PULSE BREW TIMES, PREINFUSION
TIMES and DRIP-OUT TIMES for that particular coffee
NAME. These can all be loaded in seconds.
already stored in the grinder's memory, a TAG CARD
can be obtained from the factory. The TAG CARD
would include all the information needed to set up that
particular coffee name. The information from the TAG
CARD is loaded into the grinder's memory, then into
the brewer's memory by holding the tag up to the
equipment's sensing coil. This information can in-
clude the coffee name, BREW VOLUMES, BYPASS
PERCENTAGES, PULSE BREW TIMES, PREINFUSION
TIMES and DRIP-OUT TIMES for that particular coffee
NAME. These can all be loaded in seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of TAG CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the TAG CARD, along with the coffee
name that is being programmed.
are printed on the TAG CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel (if present) from the funnel
1. Remove the funnel (if present) from the funnel
rails.
2. Position the TAG CARD vertically, so that the top
end of the TAG is beneath the funnel sensing coil.
3. After a short pause the display will read TAG
CONTAINS RECIPE FOR then will change to (COF-
FEE NAME) SHOW QUIT SAVE. All brewing pa-
rameters for that coffee flavor are now transferred
from the TAG to the brewer.
FEE NAME) SHOW QUIT SAVE. All brewing pa-
rameters for that coffee flavor are now transferred
from the TAG to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for all three batch sizes. The display
will then return to TAG CONTAINS RECIPE FOR
then will change to (COFFEE NAME) SHOW QUIT
SAVE.
brew settings for all three batch sizes. The display
will then return to TAG CONTAINS RECIPE FOR
then will change to (COFFEE NAME) SHOW QUIT
SAVE.
5. If all brew settings are correct, press SAVE. The
display will read (COFFEE NAME) SETUP COM-
PLETE. All brew settings for that name are now
stored in the brewer's memory.
PLETE. All brew settings for that name are now
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press QUIT. The
display will read (COFFEE NAME) NOT SAVED.
The display will then return to the MAIN SCREEN.
loaded into the brewer's memory, press QUIT. The
display will read (COFFEE NAME) NOT SAVED.
The display will then return to the MAIN SCREEN.
P2440
34025 100501