Bunn MCAA Manual De Usuario

• HEATING INDICATOR - This light indicates that the heater is bringing water up to temperature.

A brew cycle cannot be started until the indicator has gone out. (During a brew cycle, this

light will come on indicating the tank heater is warming the new water entering the tank.)

• POD HOLDER INDICATOR - This indicator identiﬁes a missing or unlocked pod holder.

Before a brew cycle can be started, the pod holder must be inserted and locked into place.

• TEA BREW BUTTON - Depress this button to brew a serving of tea or coffee. Pressing it

again will cancel a brew cycle in process. You will notice that the water ﬂow will pulse

on and off when brewing with this setting. This is normal. (Can also be used to brew a

stronger more robust serving of coffee.)

• VOLUME CONTROL INDICATOR - The markings on the bottom of the control panel

correspond to the VOLUME CONTROL SLIDE LEVER and are used for setting the brew

volume. (Approximately 118 to 355 ml (4 to 12 oz.) servings in 30 ml (1 oz.) increments

can be brewed based on the setting of the lever.)

NOTE: Because some pods will absorb more water than others, the ﬁnished serving size may

vary slightly.

FEATURES

• SLEEP MODE - If the brewer has been idle for 6 hours, it will reduce power to conserve

energy. After 26 hours, the brewer will shut down completely. When either of these two

sleep modes occur, the Pod Holder Release Button will no longer be glowing red. To wake

the brewer up, press either the Coffee or Tea Brew button, or eject the pod holder. The light

and heater will come back on.

• BREW CANCEL - If it is necessary to cancel a brew cycle, this can be done by pressing

either the Coffee or Tea button again. Although some water may drip out, the pump will

immediately stop forcing water through the pod holder. Always wait for hot liquid to stop

before removing the pod holder.

CAUTION: When a brew cycle is canceled, it will not ﬁnish dispensing it’s previous brew

volume when the button is pressed again. The memory is reset and the brewer will dispense

a full volume as indicated by the Volume Control Lever. This could cause a container to

overﬂow if it is not emptied prior to pressing the button a second time.
• MIN & MAX MARKINGS - The side of the water reservoir bears the markings “MIN” and

“MAX”. These markings indicate the minimum and maximum amount of water that can be

placed in the reservoir. If the minimum amount of water is not in the reservoir, the brewer

will not operate. These markings are referenced throughout this booklet.

• PULSE BREW™ - Using the Tea Button will cause the brewer to perform a pulse brew

operation. A Pulse Brew cycles the water on and off to effectively steep the tea to extract

the proper ﬂavor. The “On-Off-On” water ﬂow is normal. Always wait for the blue (brew)

lights to go out, and the red BUNN light to come back on before carefully removing the

mug or pod holder. Pressing either brew button during this operation will stop the brew

cycle. (See the “Brew Cancel” feature above for more information.)

CONTROL PANEL (Cont.)