Bunn Dual SH Manual De Usuario

3

Carefully read and follow all notices on the grinder and in this manual. They were written for your protection. All 

notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels.

20545-0000D 01/04 © 1990 Bunn-O-Matic Corporation

READ THE ENTIRE OPERATING MANUAL

INCLUDING THE LIMIT OF WARRANTY AND

LIABILITY BEFORE BUYING OR USING THIS PRODUCT

An extension cord, when used, must be shorter

than 20 feet if 16-gage 3-conductor wire, or

shorter than 10 feet if 18-gage 3-conductor wire.

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE, OR SHOCK HAZARD

Use only on a properly protected circuit
capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes.
Do not use near combustibles.

#20545.0000

KEEP FINGERS AND

FOREIGN OBJECTS

OUT OF HOPPER

OR CHUTE OPENING.

PERSONAL INJURY

HAZARD.

#05876.0000

PANTONE

Red 032 CV

PANTONE

430 CVC

PANTONE

432 CVC

PANTONE

354 CVC

PANTONE

Black C

d

d

c

b

a

36529  080706

This grinder has an attached cordset and requires 2-wire, grounded service rated:

 

120 volts ac, 15 amp, single phase, 60 Hz, for domestic grinders. 

 

230 volts ac, 10 amp, single phase, 50 Hz, for most international grinders. 

 

100 volts ac, 15 amp, single phase, for some international grinders.

Pressing initiates a timed grind cycle.

Pressing ends the operation of the grinder.

Pressing the ¨ pad allows programming access (see 

page 6).

These pads are located on the funnel depictions on each side of the grinder with a total of 6 pads. Selecting one 

of these pads will select the amount of grind and side from which to grind.

Example: Selecting the lower pad on the left side will grind enough beans from the left hopper of the grinder to 

brew the amount programmed into grinder.

The control board determines the amount of beans that will leave the hopper in a grind cycle. The timer portion 

can be adjusted to dispense a different amount from each hopper and each batch size. The scale is from 0.4 to 

99.9 seconds. Refer to the Adjustments section for timer setting chart (page 7).

#37881.0000