Bunn HG Manual De Usuario

Wash the brew funnel and glass carafe after each use – they’re top rack dishwasher safe.  

If using a thermal carafe, hand wash the carafe and lid after each use. Every 2 to 4 weeks 

remove the sprayhead and clean. Occasionally wipe the outside of your brewer, including the 

area above the funnel, with a mild, non-citrus detergent and a damp cloth. While cleaning 

your brewer, check the glass carafe handle and tighten with a standard screwdriver if it’s loose.

To disassemble the thermal carafe for cleaning, rotate lid counterclockwise to remove. Use a 

mild, non-abrasive detergent to wash the lid thoroughly – paying particular attention to the 

passage where the coffee brews through the lid. Do not use a scrub pad or other abrasive 

cleaners, as this will scratch the stainless steel carafe.

To remove coffee stains from inside the thermal carafe, place a paper filter into the brew 

funnel and pour two teaspoons of powder dishwasher detergent into the paper filter. 

Slide brew funnel into funnel guides and open spin lid. Pour one carafe of cold water into 

brewer. Position carafe on base plate of brewer and press the On/Off button. When cycle 

is complete, remove brew funnel and discard the filter and detergent; rinse brew funnel 

thoroughly. Let carafe cool for 10 – 15 minutes. Using a long-handled, soft-bristled brush, 

clean the inside of carafe and the outer rim to remove any stains or debris. Occasionally 

scrub the carafe pour lip and the area around it, including the lid, with a mild detergent and 

warm water. Use a soft cloth and scrub hard. When finished, pour solution into sink and 

thoroughly rinse carafe and lid with clean water. 

Deep clean your brewer at least every 3 months or if the digital display flashes between the 

time and ‘CLE.’ The frequency of cleaning depends on the mineral content of your water (the 

higher the mineral content, the more often you should deep clean).

Remove the sprayhead by turning with 

your fingertips.

Check the sprayhead. If plugged with  

mineral deposits or white flakes, use a 

toothpick to remove. Clean the sprayhead 

with a cloth and mild detergent. Rinse the 

sprayhead with water.

Slide empty brew funnel into the funnel 

guides under the sprayhead.

Open the spin lid on top of the brewer  

and fill brewer with water to the 6-cup  

(30 oz.) mark.

Add 2 cups (10 oz.) of white vinegar to 

brewer, filling it to the 8-cup mark.

Close the spin lid.

Place empty carafe on the base plate  

of brewer.

Press the On/Off button to cycle the  

vinegar solution through the brewer.

Empty carafe at end of cycle.

Run 2 – 3 additional cycles with full carafes 

of water to flush remaining vinegar  

solution from the brewer.

Reinstall sprayhead.