Bunn ITB/ITCB Manual De Usuario

21

Location:
 

The voltage selector switch is located on the 

component mounting bracket on the base plate.

1.  Disconnect the brewer from the power source.
2.  Disconnect the wires from the selector switch. With 

the selector switch in the 120V position, check for 
continuity between the two right terminals of the 
switch.

3.  With the selector switch in the 120/208-240V 

position, check for continuity between the two left 
terminals.

If continuity is not present as described, replace the 

switch.

Removal and Replacement:
1.  Disconnect the brewer from the power source.
2.  Disconnect the three wires from the selector 

switch.

3.  Remove the switch mounting nut from the under 

side of component mounting bracket; remove 
switch from bracket.

4.  Install new switch in component mounting bracket 

and secure with mounting nut.

42461 0911809