Bunn CDS-3 Manual De Usuario

27

FIG. 9 CIRCUIT BREAKER

P1342

Location:

The circuit breaker is located inside the dispenser 

on the upper left side of the component bracket.
Test Procedures:

1.  Disconnect the dispenser from the power source.

2.  Remove the wires from the circuit breaker.

3.  Check for continuity between the terminals. Conti-

nuity must be present between the terminals.

If continuity is present as described the circuit breaker 

is functioning properly.
If continuity is not present as described, press the reset 

button and repeat step #3, if continuity is not present 

as described, replace the circuit breaker.
Removal and Replacement:

1.  Remove the four #8-32 locking screws securing 

the component bracket to the chassis.

2.  Tip the top of the component bracket forward far 

enough to allow access to the rear of the circuit 

breaker.

3.  Remove the wires from the circuit breaker.

4.  Compress the clips on the back side of the com-

ponent bracket and gently push the circuit breaker 

through the opening in the component bracket.

FIG. 10 CIRCUIT BREAKER TERMINALS

P1330

5.  Push the new circuit breaker into the opening in 

the  component  bracket  until  the  clips  snap  into 

position.

6.  Reconnect the wires to the circuit breaker.

7.  Position  the  component  bracket  in  chassis  and 

secure with four #8-32 locking screws. 

8.   Refer to Fig. 10 when reconnecting the wires.

27646 122200

RED from Transformer

RED from Main Harness