Bunn ICB Manual De Usuario

Descargar
Página de 70
Page 15
MEMORY
  LOCK       UNLOCK
BREW
A
BREW
B
BREW
C
MAIN SCREEN
 
This screen will be shown when the brewer is ready 
for use. The screen displays the water temperature 
in the tank. When the water in the tank reaches the 
correct set temperature, the display will change from 
HEATING to READY TO BREW.
PROGRAMMING LOCKOUT SWITCH (located on the 
memory module board prior to S/N ICB0004379 
- located on the main circuit board S/N ICB0004379 
and after)
 
This switch can be set to prevent access to the 
programming settings of the brewer. Once all the cor-
rect brew settings are programmed, the operator can 
set the switch to the "ON" position to prohibit anyone 
from changing the settings. With the switch in the 
"ON" position, the programming menus can still be 
accessed to view the current settings. However, no 
changes will be saved.
PROGRAMMING THE BREWER
 
The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions 
are accessed in Level 2.
 
 The following function screens are in order of appearance. Each screen will have instructions on how to 
access and the procedures for programming the various functions of the brewer.
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY - 
 
To exit the programming mode at any time, press and release the ON/OFF pad located on the front switch 
panel. The display will return to the MAIN SCREEN.
 
If none of the fi ve programming switches are pressed within one minute during the setup of the brewer, 
the programming of the function screen that is being set will be exited and the display will return to the MAIN 
SCREEN.
 
Always remember to place a container and funnel under the sprayhead when operating the brewer during 
the set-up of CALIBRATE FLOW, and testing the brew and bypass valves in SERVICE TOOLS/TEST OUTPUTS.
PROGRAMMING 
LOCKOUT SWITCH
READY TO  BREW
WATER TEMP:  200°
P3048
37077 071206