Bunn JDF-4SB Manual De Usuario

16

P1684.40

FIG. 5 CABINET FAN

Location:
The cabinet fan is located inside the dispenser cabinet 

mounted in the center behind the fan guard cover.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Remove the four screws attaching the fan and cover 

assembly.

3.  Gently pull the cover forward and disconnect the 

2-pin connector from the main wiring harness.

4.  Check for continuity between the two wires on the 

fan.

If continuity is present as described, the fan is operat-

ing properly.

If continuity is not present as described, replace the 

fan.

Removal and Replacement:

1.  Disconnect the dispenser from the power source.

2.  Remove the four screws attaching the fan and cover 

assembly.

3.  Gently pull the cover forward and disconnect the 

2-pin connector from the main wiring harness.

4.  Remove the fan from the cover assembly and discard 

the old fan.

5.  Install the new fan to the cover assembly using 

screws previously removed.

6.  Reconnect the fan to the 2-pin connector on the 

main wiring harness.

7.  Install the fan and cover assembly to the cabinet 

using screws previously removed.

8.  Reconnect power to the dispenser.

FIG. 6 CABINET FAN TERMINALS

P1219

1

2

RED

BLK

49179  110613