Bunn JDF-4SB Manual De Usuario

32

FIG. 37 DISPENSE MOTOR

Location:

 

The Dispense Motors are located on the rear of the 

platform assembly.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.   With a voltmeter, check the voltage across the two 

wire terminals of the motor assembly. Connect the 

dispenser to the power source. The indication must 

be 24 volts ac.

3.  Disconnect the dispenser from the power source.

If voltage is present as described, replace the motor.

If voltage is not present as described, refer to the Wiring 

Diagrams and check the dispenser wiring harness back 

to the transformer (See TRANSFORMER).

Removal and Replacement:

1.  Disconnect the two wires from the dispense mo-

tor.

2.  Loosen the four #8-32 screws securing the motor 

to the platform assembly and remove the motor.

3.  Inspect the gasket and rubber bushings for signs 

of wear and replace if necessary.

4.  Position the new motor into place with the gasket 

and bushings onto the platform. Secure with four 

#8-32 screws previously removed.

5.  Reconnect the two wires to the motor as shown in 

Fig. 38.

FIG. 38 DISPENSE MOTOR CONNECTORS

49179  110613