Bunn B10 Manual De Propietario

6

OFF

O

N

NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do 

NOT plug in until Step #3.

  Raise the hinged fl ip-lid. 
  NOTE: The post protruding from the screen is con-
nected to a stopper which controls the fl ow of water 
into the tank.  When lid is closed (post depressed), the 
stopper is raised and water will fl ow into the tank.

Plug in the brewer.

Step 2
  Slide an empty brew funnel into the brewer under 
the warmer switch. Pour one decanter full of water into 
the screened area on top of the brewer. Place decanter 
on the warmer. Close lid. Wait three minutes to allow 
the water to fl ow into the tank. 

Repeat this process. 

When the tank is full, some water will fl ow through the 
funnel and into the decanter.

P2240

P2247

P-214

P-219

Step 4

Step 4
  Press the bottom of the vacation switch, located on the 

  Press the bottom of the vacation switch, located on the 
lower left side of the brewer, to the “ON” (lower) position.

lower left side of the brewer, to the “ON” (lower) position.
The vacation switch controls power to the tank heater.

The vacation switch controls power to the tank heater.
Initially  you  will  have  to  wait  approximately  fi fteen 
minutes  in  order  for  the  water  to  reach  brew  tem-
perature.
Empty any water that has collected in the decanter.  

Step 1

Step 3