Bunn 41343 Manual De Usuario

Page 37

  This function allows the operator to prevent the 

start of a brew cycle if a Smart Funnel is not positioned 

correctly in the funnel rails.

1.  Press and hold the upper right hidden switch until 

display reads UNITS. Release the switch. Continue 

to press and release switch until display reads 

FUNNEL DETECT.

2. 

NO or YES should be flashing to indicate the cur-

rent setting.

4. Select YES to prevent brewing if a Smart Funnel is 

not correctly situated in the rails.  If this function 

is activated and a brew cycle is attempted with the 

funnel not properly situated, the display will read,  

FUNNEL NOT IN PLACE, until one is in place.

5. Select NO to allow brewing without a Smart Fun-

nel in place. This is selected when brewing with a 

funnel other than a Smart Funnel (a regular brew 

funnel).

6.  When finished, press and release DONE. This 

will retain the changes, exit this function screen 

and advance to the next. Another alternative is to 

press the ON/OFF switch (either on DUAL brewers) 

located on the front switch panel to exit the FUN-

NEL DETECT and return to the MAIN SCREEN.

FUNNEL DETECT ?

 NO 

DONE 

YES

 

This function allows the testing of individual com-

ponents and the ability to check switches for proper 

function. This function also tests the funnel sensor 

coil's frequency (diagnostic tool for troubleshooting 

purposes only).

  This will allow the operator to test the operation 

of individual components and outputs of the brewer.  

The components that can be individually tested are as 

follows:

Brew Valve

Bypass

Funnel Lock (Optional)

Warmer

Refill Valve

Tank Heaters

Heater Contactor

Left Brew Valve

Left Bypass

Left Funnel Lock

Left Warmer

Right Brew Valve

Right Bypass

Right Funel Lock

Right Warmer

Refill Valve

Tank Heaters

Heater Contactor

1.  Place brew funnels into rails on both sides of 

brewer.

2.  Place a GPR beneath each brew funnel.

3.  Press and hold upper right hidden switch until the 

display reads UNITS.  Release switch. Continue 

pressing and releasing upper right hidden switch 

until SERVICE TOOLS appears. 

4. Press YES to run tests on various components 

and outputs within the brewer. Pressing NO will 

exit this function and advance to the next function 

screen.

5.  The display should read TEST OUTPUTS.

41343 080108