AEG 8.000.024.628 Manual De Usuario

5

 

The load resistance also has to be connected externally to the current converters. Within 

standard default setting the following measurement values are read out: output 1 - 
measurement value 1, output 2 - measurement value 2, output 3 - measurement value 3. 

The following figure displays the principle structure and the connection diagram if using as 

additional measurement device. 

 

 

No settings are necessary for the additional measurement device. Converters or load 
resistances have to be configured in a manner so that a 1V~ measurement voltage is 

generated at a nominal electrical current. Thus, a voltage of 10V- results at the respective 

analog output. 

 

 
If the additional measurement device is also used as network peak load monitoring, limiting 

value could be set via the help of the potentiometer R310. Standard setting is 200%, the 

6

 

potentiometer is set on right stop, whereby 100% meaning 1V~ at the measurement inputs / 

load resistances. 

 

 

 

The commissioning of the unit is permitted only upon expert installation! 

 

For this see the currently valid AEG Power Solutions operating manual 
of Thyro-Power Manager. 

 

 

Mains voltage - Danger! 

 

Activate the unit only if it is secured that all necessary measures for 
protection against electric shock are implemented. 

 

Enabling mains voltage during regular operation activates the unit. Subsequently, the green 

power LED H100 and the green ON LED H101 should burn. If network load optimization is 

used, the LEDs H201 - H210 turn ON one after another (contingent to the selected number). 

All measurements and functions are performed as selected.