Beko UL584APS Manual De Usuario

EN

8

1.  The appliance should be transported 

only in a vertical upright position. The 
packing as supplied must be intact 
during transportation.

2.  If during the course of transport the 

appliance has to be transported 
horizontally, it must only be laid on its 
right hand side when standing in the 
front of the appliance. After bringing 
it to upright position,it must not be 
operated for at least 4 hours to allow 
the system to settle.

3.  Failure to comply with the above 

instructions could result in damage 
occuring to the appliance. The 
manufacturer will not be held 
responsible if these instructions are 
disregarded.

4.  The appliance must be protected 

against rain, moisture and other 
atmospheric influences.

5.  Empty any water in the drain 

tray before moving see section 
“Defrosting” and “Cleaning & Care” 
for further information

IMPORTANT :
Make sure the plastic evaporating pan 
at the back of the product collects 
water properly. 
IMPORTANT:
Care must be taken while cleaning 
/ carrying the appliance to avoid 
touching the bottom of the condenser 
metal wires at the back of theappliance 
as you might injure your fingers and 
hands.
IMPORTANT: 
This appliance is not designed for 
stacking with any other appliance.

When positioning your appliance, take 
care not to damage your flooring, 
pipes,wall coverings etc. Do not 
move the appliance by pulling by the 
door or handle.Do not attempt to sit 
or stand on top of your appliance as 
it is not designed for such use. You 
could injure yourself or damage the 
appliance.
IMPORTANT:
Make sure that mains cable is not 
caught under the appliance during and 
after carrying / moving the appliance, 
to avoid the mains cable becoming cut 
or damaged.”Do not allow children to 
play with the appliance or tamper with 
the controls.
BEKO declines to accept any liability 
should the instructions not be 
followed.

1.  If possible avoid placing the appliance 

near cookers, radiators or in direct    
sunlight as this will cause the 
compressor to run for long periods. 
If installed     next to a source of heat 
or refrigerator, maintain the following 
minimum side clearances:

From Cookers   2”   (50 mm)
From Radiators  12” (300 mm)
From Refrigerators or Larder Fridge 1”   
(25 mm)
2.  No gap is required at sides and top. 

See item 3 below to ensure a gap is 
obtained at the rear of the appliance. 
If a gap is available on side and 
top, retain it if possible as it would 
improve the air circulation around the 
appliance.