Crane Merchandising Systems 678 Manual De Usuario
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001
Page - 65
November, 2002
SET UP YOUR SELECTION:
Follow the instructions in the PRODUCT CONFIGURATION section
of the Hot DRINK Operator's Guide.
of the Hot DRINK Operator's Guide.
1. Make sure the machine is configured to use 12 oz. cups.
2. Set up the 1D selection as follows:
2. Set up the 1D selection as follows:
a. Coffee: 17 grams
b. Sugar: 2.5 grams
c. Lightener: 5 grams
d. Water: 6 ounces (about 177 ml)
e. Steep time: 12.5 seconds
f. Whip: ON +
b. Sugar: 2.5 grams
c. Lightener: 5 grams
d. Water: 6 ounces (about 177 ml)
e. Steep time: 12.5 seconds
f. Whip: ON +
To get these measurements, refer to PRODUCT CONFIGURATION.
See COLLECTING DRY PRODUCT GRAM THROWS, and perform
test throws of the dry ingredients. See COLLECTING WATER
THROWS, and perform test water throws.
See COLLECTING DRY PRODUCT GRAM THROWS, and perform
test throws of the dry ingredients. See COLLECTING WATER
THROWS, and perform test water throws.
EUROPEAN CAPPUCCINO
First, a portion of cappuccino topping mix (or lightener) is dispensed,
then layered on top is a small serving of strong coffee.
then layered on top is a small serving of strong coffee.
1. Replace product in the soup (or international coffee) canister with
the lightener or cappuccino topping mix.
the lightener or cappuccino topping mix.
2. Enter the Supervisor code: Press
. The display shows:
ENTER CODE
. You must enter the four-digit supervisor code within
6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor
code of
code of
0000.
When you have entered the right code, you will hear two beeps
and see
SUPERVISOR
in the display. Press
.
3. Reconfigure the machine:
EUROPEAN CAPPUCCINO RECIPE