Crane Merchandising Systems 6530006 Manual De Usuario
Hot Drink Center Set-Up Manual
6530006
15
March, 2001
INITIAL SET-UP
I. Location Preparation
After your machine is unpacked and placed near its permanent location, you need
to make sure you have the proper electrical and water service.
to make sure you have the proper electrical and water service.
This merchandiser needs electrical power as shown in the following table.
NOTE: Each merchandiser should have its own electrical circuit.
NOTE: Each merchandiser should have its own electrical circuit.
This merchandiser is supplied with a service cord for the country of use and is
terminated in a grounding type plug. The wall receptacle used for this merchan-
diser must be properly polarized, grounded, and of the correct voltage. Operating
the merchandiser from a source of low voltage will VOID YOUR WARRANTY.
Each merchandiser should have its own electrical circuit and that circuit should
be protected with a circuit breaker or fuse conforming to local regulations.
terminated in a grounding type plug. The wall receptacle used for this merchan-
diser must be properly polarized, grounded, and of the correct voltage. Operating
the merchandiser from a source of low voltage will VOID YOUR WARRANTY.
Each merchandiser should have its own electrical circuit and that circuit should
be protected with a circuit breaker or fuse conforming to local regulations.
Voltage Check - Place the leads of a voltmeter across the LINE (LIVE) and
NEUTRAL terminals of the wall receptacle. The voltmeter should indicate
110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230
volt, 50 Hz locations.
NEUTRAL terminals of the wall receptacle. The voltmeter should indicate
110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230
volt, 50 Hz locations.
Polarity Check - Place the leads of a voltmeter across the LINE (LIVE) and
GROUND terminals of the wall receptacle. The voltmeter should indicate
110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230
volt, 50 Hz locations.
GROUND terminals of the wall receptacle. The voltmeter should indicate
110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230
volt, 50 Hz locations.
Noise Potential Check - Place the leads of a voltmeter across the NEU-
TRAL and GROUND terminals of the wall receptacle. The voltmeter
should indicate 0 volts ac. A measurement greater than 1.5-2.0 volts ac
could result in problems for the merchandiser's electronic circuitry caused by
electrical noise.
TRAL and GROUND terminals of the wall receptacle. The voltmeter
should indicate 0 volts ac. A measurement greater than 1.5-2.0 volts ac
could result in problems for the merchandiser's electronic circuitry caused by
electrical noise.
Any deviation from these requirements could result in unreliable performance
from your merchandiser.
from your merchandiser.
Power Requirements
Country
Volts
Frequency (Hz)
Current (Amps)
Canada
115
60
15
France
230
50
10
Germany
230
50
10
United Kingdom
230
50
10
United States
115
60
15