Insys GSM 4.2 I4 11-02-01-03-01.038 Manual De Usuario
Los códigos de productos
11-02-01-03-01.038
INSYS GSM 4.2 I4
Initial Operation
Dez-06
23
2.
Select the following standard setting for the serial interface in the menu “Inter-
face” at the configuration PC:
face” at the configuration PC:
3.
If the device is in an undefined state, reset it first optionally to the factory settings
using the button "Send default settings").
using the button "Send default settings").
4.
If the device does not respond to the transmission of commands, select the button
"Synchronize RS232" to adapt the baud rate and the data format automatically.
"Synchronize RS232" to adapt the baud rate and the data format automatically.
5.
In the tab "Basic settings” enter the PIN of the SIM card in the group "GSM connec-
tions” in the entry field “New pin.
tions” in the entry field “New pin.
The PIN is stored in the device and is used for logging into the GSM network at
every restart.
every restart.
6.
Send the setting using the button "Send values".
7.
Check the field strength of the GSM signal using the button "Read field strength
now in the tab "Basic settings" in the group "GSM connection".
now in the tab "Basic settings" in the group "GSM connection".
The field strength is displayed:
The GSM signal should have a field strength of at least 12. (see Chap. 3.9)
For lower values or the value 99 you will need to change the antenna location.
Note
After changing the antenna location, wait 5 to 10 seconds. Only
now will the device display the field strength correctly.
After changing the antenna location, wait 5 to 10 seconds. Only
now will the device display the field strength correctly.