BLOOMFIELD 8871 Manual De Usuario

 

Unpack the unit.  Inspect all components for completeness and 
condition.  Ensure that all packing materials have been removed 
from the unit.  

 
Verify that the Spray Head Gasket and Spray Disk are properly 
installed.   

 

 
Verify that slip-resistant foot is installed at each corner of the 
warmer. 

 
Set warmer in its operating location.  Level the warmer.  A spirit 
level should be placed on the top of the unit, at the edge, as a 
guide when making level adjustments. 
 
ELECTRICIAN’S INSTALLATION INSTRUCTIONS 

 
REFER TO ELECTRICAL SPECIFICATIONS  -  Page  1 
Check the nameplate to determine correct electrical service 
required for the Brewer to be installed. 
 
Warmer models 8708, 8851, 8852, 8871 and 8872 are   
equipped with a cord and plug.  They require a 115 - 125 volt    
15 amp circuit (50/60 Hz,  2 wire plus ground, with NEMA 5-15R 
receptacle). 
 
 

CAUTION: 

 

DO NOT plug in or energize this 
appliance until all Installation    
Instructions are read and          
followed.   
Damage to the Brewer will occur 
if these instructions are not      
followed. 

 

 
It is very important for safety and 
for proper operation that the 
brewer is level and stable when 
standing in its final operating    
position.  Provided adjustable, 
non-skid legs must be installed at 
each corner of the unit.. Failure to 
do so will result in movement of 
the brewer which can cause    
personal Injury and/or damage to 
brewer. 
 

 

SHOCK HAZARD 

 

Brewer must be properly 
grounded to prevent possible 
shock hazard.  DO NOT assume 
a plumbing line will  provide such 
a ground.  Electrical shock will 
cause death or serious injury. 
 
 
IMPORTANT:  
The ground prong of the plug is 
part of a system designed to    
protect you from electrical shock 
in the event of  internal damage.  
Never cut off the ground prong 
nor twist a blade to fit an         
existing receptacle.  Contact a 
licensed electrician to  install the 
proper circuit and receptacle. 

4