Philips PPX2450 Manual De Usuario

You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).

A tripod accessory is available if you want to elevate the
device.

1 Insert the small plug of the power supply into the

socket on the rear side of your device. 

2 Plug the power supply into the mains.

3 During the charging process, the indicator light on

the side of the device will be red. When the battery
is fully charged, it will turn green.

4 Charge the built-in battery before using for the first

time for at least 3 hours. This will prolong the life of
the battery.

1 Switch the device on using the on/off switch on the

side.

2 Turn the device towards a suitable projection sur-

face or wall. Note that the distance to the projection
surface must be a minimum of 0.5 meters and a max-
imum of 5 meters. Make sure the projector is in a
secure position.

3 Use the focus wheel on the top to adjust the image

sharpness.

4 Select the desired menu language using ¡/¢.

5 Confirm with à.

Check whether the mains voltage of the
power supply matches the mains voltage
available at the setup location.

The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Use the navigation keys to select Set-

tings.

2 Confirm with à.
3 Select with ¡/¢ Language.
4 Confirm with à.
5 Select the desired language with ¡/¢.
6 Confirm with à.
7 Exit with ¿.