NuTone NS136SS Manual De Usuario

For performance, appearance, and health reasons, clean filter, 

fan and grease-laden surfaces. Use

only a clean cloth and mild

detergent solution on stainless and painted surfaces. Clean all-

metal filters in the dishwasher.
The motor is permanently lubricated and never needs oiling. If

the motor bearings make excessive or unusual noise, replace 

the motor with the exact service motor. The impeller should also 

be replaced.
Use 120 V, 50 W, shielded halogen bulbs - MR16 or PAR16 with

GU10 base. Purchase bulbs separately.

The grease filters, bottom panel, and blower wheel should be 

cleaned frequently. Use a warm detergent solution. The grease

filters and blower wheel are dishwasher safe.
Note: Some  minerals,  when  in  contact  with  dishwasher  soap 

additives, may cause filters to discolor. This discoloration 

is not covered by the warranty.

To remove blower wheel: Pull wheel straight down and off of 

motor.
When reinstalling blower wheel, make sure

taB on wheel fits 

into one hole on motor.

SOFFIT

24" - 30" ABOVE

COOKING SURFACE

CABINET

3¼" X 10" DUCT

(For horizontal discharge)

WALL CAP

ROOF CAP

3¼" X 10" or

7" ROUND DUCT

(For vertical

discharge)

HOUSE WIRING

(Top or Back of hood)

HOOD

HOOD

1 

Determine whether hood will discharge vertically (3¼” x 

10” or 7” Round), or horizontally (3¼” x 10” only). For ver-

tical or horizontal discharge, run ductwork between the

hood location and a roof cap or wall cap. For best results,

use a minimum number of transitons and elbows.

2

Use the proper diagram below, for placement of ductwork

and electrical cutout in cabinet or wall. For a non-ducted

installation, DO NOT cut a duct access hole.

*

  Note the extra wood shim and mounting screw near    

 the  cabinet  front,  2-3/8”  to  the  right  of  the  cabinet

 center line.

VERTICAL DUCT

ACCESS HOLE

¾"

10

3/4

"

5¼"

5¼"

HOOD MOUNTING SCREWS (5)

ELECTRICAL

ACCESS HOLE

(in cabinet bottom)

WOOD SHIMS

(recessed-bottom

cabinets only)

15¼" 

(36" hood)

4½"

1

7/8

"

15¼" 

(36" hood)

12¼" 

(30" hood)

12¼" 

(30" hood)

1

7/8

"

2

3/8

" 

*

10

7/8

"

Always turn the hood ON before cooking in order to establish an

air flow in the kitchen. After turning off the range, let the hood run 

for a few minutes to clear the air.
Operate the hood as follows:

HC0020

This  3-position  rocker  switch  turns  blower  ON  and  OFF  and

controls blower speed.
Press left side of rocker (1) to turn blower ON to low speed.
Press right side of rocker (2) to turn blower ON to high speed.
Set rocker to middle position (0) to turn blower OFF.

This 3-position rocker switch turns lights ON and OFF and controls

their intensity.
Press left side of rocker (1) to turn lights ON to low intensity.
Press right side of rocker (2) to turn lights ON to high intensity.
Set rocker to middle position (0) to turn lights OFF.

TAB