GE ZV541 Manual De Usuario

• Select the template for your hood size.
• Align the template with the marks on the ceiling and

tape in place.
– Be sure the template is oriented correctly,

with the front of the hood.

• Use a plumb to check to be sure the mounting

holes will provide parallel alignment with the
countertop below.

• Center punch all hole locations.
• Drill pilot holes in the 4 screw locations. Use a

3/16” bit and drill approximately 1-1/2” deep. 

• Drive 4 Hex head wood screws (Screws A) into

the center of the ceiling joists and cross framing.
Leave a 1/4" gap to allow the screw head to
engage the keyhole slots on the support frames.

• Cut the 10-1/2" duct opening through the sheet

rock.

• Measure from house duct flange to bottom of 

support frame. Subtract 4-3/8" for clearance to the 
bottom of the support frame. 

• Cut the 10” duct length to size.
• Secure duct to house ducting with sheet metal screws.
• Seal all connections with duct tape.
• Attach the duct collar loosely, about 1" from the bottom

of the duct using Screws B.

1/4" Gap

Duct

Length

4-3/8" Clearance
to Bottom of Frame

Duct

Collar

House

Duct

Duct