Zephyr AK8300ASX Manual De Usuario

 To assure continued compliance, any changes or modifi cations not expressly approved by the party 

responsible for compliance could void the user’s authority to operate this equipment.  (Example - use only shielded interface 
cables when connecting to computer or peripheral device.  This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions.  (1) This device may not  cause harmful interference, and (2) This device must accept 
any interference received, including interference that may cause undesired operation.

Clean the remote control using non abrasive detergents

Follow instructions below for replacing battery.
Using a small fl at head screwdriver, raise the cover of the battery door (A)
in order to access the battery compartment.

Remove the battery and replace with Type A23 12V.                                     
Negative end of battery should face the spring inside the remote.

Replace battery door and recycle old battery.

By pressing      , the blower is switched On.  Press        again to cycle through all 
three blower speeds. 

By pressing      , the blowers will power on at the last speed setting.  Press 
again and the entire hood will power off, including lights.

Switch lights On by pressing       once, again to dim and again to switch Off.

Blower On/

Speed Selection

1

1

2

3

4

Blower On/
Power Off

2

5 Min Delay Off

3

Lights On/Dim/Off

4

By pressing      , the blower and lights will enter Delay Off mode.  A dot will 
appear in the lower right corner of the power pack display        indicating the 
function is on.  The blower will change to speed 1 and shut down after 5 
minutes.

-

+

The RF remote control is equipped with a magnet for easy storage.  The remote may be placed on any magnetic surface such 
as a refrigerator or the Zephyr remote holder.  Maximum remote control communication distance from power pack is 15 feet.

This remote control may operate in humid environments, but not when placed on a wet surface.

To create a unique link between your range hood and remote control please follow the below steps:

1. With range hood off, press and hold the “lights” button on the range hood until the letter “F” shows on the display screen. 
2. Press the “lights” button on the remote, the lights on the hood will turn on. The synchronization is complete.