Panasonic GN SERIES Manual De Usuario
Product Description
GN Series Hardware Manual
34
4. Lift the cover, for example with a screwdriver, to access the terminal screws
5. Turn the terminal screws counter-clockwise to loosen
6. Insert the wires into the corresponding terminals
6. Insert the wires into the corresponding terminals
Make sure that the polarity is correct!
7. Turn the screws clockwise to tighten
OK
8. Close the cover
9. Prepare the other end of each wire for connection to the DC power supply
9. Prepare the other end of each wire for connection to the DC power supply
3.8.2 Connecting to the DC Power Supply
Connect the GN panel to a DC power supply using the DC power plug and a corresponding
cable (see page 34).
The DC power supply must be able to output 50W to cope with the inrush current.
The DC power supply must be able to output 50W to cope with the inrush current.
NOTE
•
The DC power supply should be able to be switched off and on via an
isolating switch.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net