Toro 4043 Manual De Usuario
Greensmaster eFlex 1800/2100
Page 5 -- 5
Chassis and Controls
7. Remove handle clamps from handle assembly (Fig.
3).
A. Remove carriage screws and flange nuts that se-
cure handle clamps to offset handle clamps.
B. Remove flange nuts that secure shoulder bolts at
bottom of handle clamps.
C. Remove inner handle clamps. Leave shoulder
bolts and outer handle clamps in place on handle.
8. Remove the handle assembly from the machine.
Handle Installation (Fig. 2)
1. Position handle assembly to outer handle clamps on
machine.
2. Fit inner handle clamps to the handle assembly and
secure with removed fasteners (Fig. 3). Adjust handle
height before fully tightening the fasteners.
NOTE: The handle is traditionally operated with the
handle adjusted to the maximum height.
3. Attach reel clutch and brake cables to transmission
(see Cable Replacement in this section). Check cable
operation and adjust if necessary.
4. Attach wire harness connections to electrical com-
ponents on handle.
5. Secure console cover to handle assembly.
6. Connect the battery pack (see Battery Pack Connec-
tion in this section).
1. Handle
2. Offset handle clamp
3. Carriage screw
4. Carriage screw
5. Shoulder bolt
6. Bushing
7. Rubber bumper
8. Handle retainer
9. Hair pin
10. Side plate (LH shown)
11. Flange nut
12. Flange nut
13. Handle clamp
Figure 3
FRONT
RIGHT
2
3
6
8
9
10
1
5
7
4
6
6
11
12
13
eFlex 2100
1. Handle
2. Offset handle clamp
3. Carriage screw
4. Carriage screw
5. Shoulder bolt
6. Bushing
7. Rubber bumper
8. Handle retainer
9. Hair pin
10. Side plate (LH shown)
11. Flange nut
12. Flange nut
13. Handle clamp
Figure 4
FRONT
RIGHT
eFlex 1800
8
9
6
10
13
2
3
4
12
7
5
12
6
6
11
1
Chas
sis
and
Controls