Maytag W10359302A Hoja De Datos

1. Remove the rack/bin by lifting it and pulling it straight out.

2. Replace the rack/bin by sliding it in above the desired 

support and pushing it down until it stops.

1. Remove the utility compartment by raising and holding the 

cover up while lifting the utility compartment up and pulling it 
straight out.

2. Replace the utility compartment by sliding it in above the 

desired support and pushing it down until it stops.

1. Hold the can caddy with one hand and pull up until it is 

released from the door liner. Then, pull up on the caddy again, 
until the stoppers have been overcome. 

2. Pull the can caddy straight out to remove it from the door. 

3. Replace the can caddy by aligning the grooves on the sides 

with the pins in the door liner. Push up on the bottom of the 
caddy until the stoppers have been overcome, and slide it 
fully into the compartment. 

IMPORTANT: For models with a water filter, after connecting the 
refrigerator to a water source or replacing the water filter, fill and 
discard three full containers of ice to prepare the water filter for 
use. 

To turn the ice maker ON, simply lower the wire shutoff arm.

To manually turn the ice maker OFF, lift the wire shutoff arm to the 
OFF (arm up) position and listen for the click.

NOTE: Your ice maker has an automatic shutoff. As ice is made, 
the ice cubes will fill the ice storage bin and the ice cubes will 
raise the wire shutoff arm to the OFF (arm up) position. Do not 
force the wire shutoff arm up or down.

1. Wash the ice storage bin with mild soap and warm water.

2. Slide the ice storage bin under the ice maker, and push it 

toward the back as far as it will go.

3. Lower the arm on the ice maker to the “on” position. 

NOTE: It usually takes approximately 24 hours for the ice 
maker to begin producing ice. You may notice the ice has an 
“off-taste.” If so, discard the first three batches of ice 
produced. After that the “off-taste” should be gone.

■

The ice maker should produce approximately 8 to 12 batches 
of ice in a 24-hour period. Allow 3 days to completely fill the 
ice container. 

■

To increase ice production, lower the freezer and refrigerator 
temperature. See “Using the Control(s).” Wait 24 hours 
between adjustments.

■

The quality of your ice will be only as good as the quality of 
the water supplied to your ice maker. Avoid connecting the 
ice maker to a softened water supply. Water softener 
chemicals (such as salt) can damage parts of the ice maker 
and lead to poor quality ice. If a softened water supply cannot 
be avoided, make sure the water softener is operating 
properly and is well maintained.

■

Do not use anything sharp to break up the ice in the bin. This 
can cause damage to the ice storage bin and the dispenser 
mechanism.

■

Do not store anything on top of or in the ice maker or ice 
storage bin.