Maytag W10359302A Hoja De Datos

5. Open refrigerator door and remove base grille from the 

bottom front of the refrigerator. 

6. Using a hex head socket wrench, remove the two 

⁵⁄₁₆" hex 

head hinge screws attaching the bottom hinge to the cabinet 
and remove the hinge from the bottom of the refrigerator 
door.

NOTE: For 21 cu ft models, remove both the Bottom Hinge 
assembly and the leveling foot. 

7. Lower the refrigerator door from the Center Hinge.

8. Remove the washer from the bottom of the Center Hinge pin.

9. Using a hex head socket wrench, remove the three screws 

from the center hinge and remove the hinge. Set aside.

IMPORTANT: 

Your refrigerator has handles that either extend from the door or 
cup handles which are recessed into the doors. If your model has 
cup handles, disregard instructions pertaining to moving the 
handles to the opposite side. 

■

See complete graphics later in these instructions.

1. Remove the three screws (that match the exterior finish) from 

the handle side and use them to fill the holes created when 
the hinge screws were removed. 

2. Using the three 

⁵⁄₁₆" hex head hinge screws, removed in 

Step 9, insert two screws halfway into the holes, leaving 
space to insert the Center Hinge.

3. Slide the center hinge, from the right, onto the screws, insert 

the third screw, and tighten all screws completely.

NOTE: Make sure the washers are in place on both the top 
and bottom pins of the center hinge.    

⁵⁄₁₆

A

A

A

B

⁵⁄₁₆

Door Handle

Screw Hole Plug

Round-Head

Handle Screw

A

A

A

B