Hearth & Home Technologies VRT-GR-B-CE Manual De Usuario

28

Heat & Glo  •  VRTIKL-CE  •  7031-292 Rev E  •  12/07

Turn the gas stove OFF and let it cool down before replacing 
the inner glass door assembly.

With the front door assembly removed from the gas stove, 
remove the inner glass door assembly by disengaging the 
spring-loaded latches at the bottom of the gas stove and 
lifting off of the two spring-loaded latches at the top of the 
gas stove.

Replace with a new inner glass door assembly.

Remove the front door assembly by pulling bottom of front 
away from gas stove and lifting it off of the hooks on top of 
the gas stove (see Figure 8.15). 

Refer to Figure 8.16: Position the four fl at 6 mm spacer 
washers on the front door so that the four mounting screws 
pass through them. Position the glass over the front door.

Install the four protective barrels into the glass and the four 
nylon washers on top of the glass.

From inside the door front, pass the screws through to the 
outside and thread on the caps until tight.

Nylon washer on back
and front of glass

Screw

Finishing Cap

Protective barrel sleeve
through hole in the glass

Back side of

front door

Handle glass assembly with care.

•  Inspect the gasket to ensure it is undamaged.
•  Inspect the glass for cracks, chips or 

scratches.

•  Do NOT strike, slam or scratch glass.
•  Do NOT operate gas stove with glass door 

removed, cracked, broken or scratched.

•  Replace glass assembly as a complete 

assembly.