Dacor RR30NIS[-C] Manual De Usuario

Installation Specifications

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

30 1/16” (76.2 cm)

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (9.5 mm)

 countertop overhang

1” min. (2.6 cm)

to any combustibles 

above counter both sides

20”

 (50.8 cm)

to

23”

 (58.4 cm)

20”

 (50.8 cm)

24 5/8”

 (62.5 cm)

max.

Countertop front

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

30 1/16” (76.2 cm)*

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (9.5 mm)

 countertop overhang

1” min. (2.6 cm)

to any combustibles 

above counter both sides

23”

 (58.4 cm)

24 5/8”

 (62.5 cm)

max.

Countertop front

* To create a “built-in look” on the front of the cabinet, 

this dimension may be changed to 29 1/4” (74.3 cm), 

with the width at the notches remaining 30 1/16”. 

This configuration is only for models RR30NIS and 

RR30NIFS with the side panels behind the door 

removed.

•

The self-rimming installation of the RR30NI[F]S range 

creates a “built-in” look where the range trim overlaps 

and rests on the countertop on both sides and in back.

•

IMPORTANT: When installing the range in this 

configuration, ventilation must be provided to allow 

for cooling of the ranges internal components. See 

diagram, left.

•

Observe all vertical cabinet clearances on page 5.

•

On self-rimming installations when sliding the range into 

position, it will stop when the rear of the control panel or 

side panels contact the notches toward the front of the 

countertop.

Cut 3” dia. (7.6 cm) holes

at back bottom of cabinet 

for ventilation.

Provide ventilation through 

cabient both sides,

7 square inches min.

Location may vary.

34 3/4”

 (88.3 cm)

to

36 7/8”

 (93.7 cm)

(see diagrams)

Countertop

1 5/8 (41.1 cm)

max. thickness