Furuno FAR-3230SW-BB Manual De Usuario
3. TARGET TRACKING (TT)
3-22
3.17
Criteria for Selecting Targets for Tracking
The FURUNO TT video processor detects targets in midst of noise and discriminates
radar echoes on the basis of their size. Target whose echo measurements are greater
than those of the largest ship in range or tangential extent are usually land and are
displayed only as normal radar video. All smaller ship-sized echoes that are less than
this dimension are further analyzed and regarded as ships and displayed as small cir-
cles superimposed over the video echo.
radar echoes on the basis of their size. Target whose echo measurements are greater
than those of the largest ship in range or tangential extent are usually land and are
displayed only as normal radar video. All smaller ship-sized echoes that are less than
this dimension are further analyzed and regarded as ships and displayed as small cir-
cles superimposed over the video echo.
When a target is first displayed, it is shown as having zero true speed but develops a
course vector as more information is collected. In accordance with the IMO require-
ments for TT, an indication of the motion trend should be available within 20 scans of
antenna and full vector accuracy within 60 scans. The FURUNO TT complies with
these requirements.
course vector as more information is collected. In accordance with the IMO require-
ments for TT, an indication of the motion trend should be available within 20 scans of
antenna and full vector accuracy within 60 scans. The FURUNO TT complies with
these requirements.
Echo detection (quantization)
The entire picture is converted to a digital from called "Quantized Video." A sweep
range is divided into small segments and each range element is "1" if there is radar
echo return above a threshold level, or "0" if there is no return.
range is divided into small segments and each range element is "1" if there is radar
echo return above a threshold level, or "0" if there is no return.
The digital radar signal is then analyzed by a ship-sized echo discriminator. As the an-
tenna scans, if there are five consecutive radar pulses with 1's indicating an echo pres-
ence at the exact same range, a target "start" is initiated. Since receiver noise is ran-
dom, it is not three-bang correlated, and it is filtered out and not classified as an echo.
tenna scans, if there are five consecutive radar pulses with 1's indicating an echo pres-
ence at the exact same range, a target "start" is initiated. Since receiver noise is ran-
dom, it is not three-bang correlated, and it is filtered out and not classified as an echo.
The same is true of radar interference. Electronic circuits track both the closest and
most distant edges of the echo. At the end of the scanning of the echo, the discrimi-
nator indicates the measured maximum range extent and total angular extent sub-
tended by the echo. If the echo is larger than a ship-sized echo in range extent and/or
angular width, adjusted as a function of range, it is declared to be a land. This land
echo is not used by TT acquisition and tracking process. All smaller echoes are de-
clared to be ship sized and the middle of the leading edge is used to provide precise
range and bearing coordinates of each echo on every scan. This range/bearing data
is matched to previous data and analyzed from scan-to-scan for consistency. When it
is determined to be as consistent as a real target, automatic acquisition occurs and
tracking is initiated. Continued tracking and subsequent calculation develop the rela-
tive course and speed of the target.
most distant edges of the echo. At the end of the scanning of the echo, the discrimi-
nator indicates the measured maximum range extent and total angular extent sub-
tended by the echo. If the echo is larger than a ship-sized echo in range extent and/or
angular width, adjusted as a function of range, it is declared to be a land. This land
echo is not used by TT acquisition and tracking process. All smaller echoes are de-
clared to be ship sized and the middle of the leading edge is used to provide precise
range and bearing coordinates of each echo on every scan. This range/bearing data
is matched to previous data and analyzed from scan-to-scan for consistency. When it
is determined to be as consistent as a real target, automatic acquisition occurs and
tracking is initiated. Continued tracking and subsequent calculation develop the rela-
tive course and speed of the target.
524
TT Man ACQ 95%
Caution
The capacity for manual acquisition
has reached 95%.
has reached 95%.
525
TT Man ACQ 100%
Warning
The capacity for manual acquisition
has reached 100% and no more tar-
get acquisition is possible. Cancel
tracking on unnecessary targets.
has reached 100% and no more tar-
get acquisition is possible. Cancel
tracking on unnecessary targets.
526
TT CPA/TCPA
Alarm
Tracked target on collision course.
Take evasive action.
Take evasive action.
527
TT Lost
Warning
Tracked target lost. Check target.
528
REF Target Lost
Warning
Tracked target used for speed input
is lost. To continue using reference
target for speed input, select anoth-
er tracked target.
is lost. To continue using reference
target for speed input, select anoth-
er tracked target.
Alert
No.
Message
Category
Description