Furuno FAR-3230SW-BB Manual De Usuario
7. HOW TO MANAGE CHARTS
7-6
7.4
How to Install C-MAP Charts
Synchronize chart data before you install C-MAP charts, grouping the chart radar units
to synchronize, otherwise the chart data cannot be shared. See the procedure in
paragraph 7.20.1 for how to synchronize chart data. If C-MAP charts are not synchro-
nized after installation, delete all C-MAP charts, and do the above procedure again.
to synchronize, otherwise the chart data cannot be shared. See the procedure in
paragraph 7.20.1 for how to synchronize chart data. If C-MAP charts are not synchro-
nized after installation, delete all C-MAP charts, and do the above procedure again.
7.4.1
How to register the eToken
The eToken is a hardware mechanism (installed inside the processor unit) used for
password authentication. Registration of the eToken is required only once, before you
install the C-MAP database.
password authentication. Registration of the eToken is required only once, before you
install the C-MAP database.
1. Get into the Chart maintenance mode then click the [License] button on the
InstantAccess bar to show the [License] dialog box.
2. Click the [C-MAP] tab to the show the [Licenses] dialog box for C-MAP.
3. Click the [C-MAP Setup] button.
4. The confirmation message "Attention: C-MAP eToken will be initialized. Do you
4. The confirmation message "Attention: C-MAP eToken will be initialized. Do you
wish to continue?" appears. Click the [OK] button to continue and register the eTo-
ken.
ken.
Note 1: "CMAP: No connection to eToken" disappears from the Permanent warning
box after completion of the registration.
box after completion of the registration.
Note 2: You can show your C-MAP system ID by clicking the [C-MAP SystemID] but-
ton on the [Licenses] dialog box for C-MAP.
ton on the [Licenses] dialog box for C-MAP.
7.4.2
How to install the C-MAP database
When you install the C-MAP database from a medium, all data is saved to the SSD.
Note 1: If several chart radar units are installed, synchronize C-MAP charts among
the units after you have installed the database.
the units after you have installed the database.
Note 2: The installation of a chart cannot be cancelled while it is in progress. If you get
an error message, try to install the charts again.
an error message, try to install the charts again.
Note 3: Disable the Chart Alert function at the [CheckArea] page of the [Overlay/NAV
Tools] box (see section 11.2) before removing any C-MAP charts.
Tools] box (see section 11.2) before removing any C-MAP charts.
Note 4: The C-MAP database in the units selected for synchronization are synchro-
nized at the successful completion of the database installation.
nized at the successful completion of the database installation.
C-MAP system ID
appears here.
appears here.