Furuno fcr2827w Manual De Usuario
3. SETTING AND ADJUSTMENT
3-42
3.11 Adjustments for LAN Adapter EC-1010
Before adjusting LAN adapter and updating program
The following tools are needed for programming LAN adapter:
• Ordinary serial line cross-cable to make connection from COM1 port to Connector J13 of
• Ordinary serial line cross-cable to make connection from COM1 port to Connector J13 of
LAN Adapter (9 pins female – 9 pins female).
You need to set the jumpers of the LAN adapter to enable connector J13 and programming
mode.
To change J1 (CH 1) connector to J13 Connector for programming, set as below.
J17 GND
J14 TXP
J15 RXP
J14 TXP
J15 RXP
To enable manual startup and programming, set as below.
J16 INIT-GND
* See page 3-46 for parts location.
IP address agreement for LAN Adapter
Below is a table where you can find IP addresses for each device.
Device
First chart processor
Second chart processor
First LAN adapter
10.0.0.194
10.0.0.196
Second LAN adapter
10.0.0.195
10.0.0.197