Furuno 2827W Manual De Usuario

2. WIRING 

Two cables are terminated at the monitor unit: the signal cable from the processor unit and 
the power cable from the ship’s mains. The signal cable comes with a connector 
preattached to it for connection to the monitor unit. Fabricate the power cable as below. Use 
DPYC-2.5 (Japan Industry Standard) cable or the equivalent. 
For MU-231, see its Operator’s Manual. 
 

1.  Cut armor of the cable by 40 mm. 
2.  Cut vinyl sheath by 35 mm. 
3.  Remove insulation of wires by about 10 mm. Fix crimp-on lugs to the cores. 
4.  Peel point of the armor by 40 mm. 
5.  Cover the end of armor with vinyl tape. 

40 mm: Peel paint.

Taping

(a)

(b)

(d)

Armor

35 mm

10 mm

(c)

Approx. 40 mm

DPYC-xx

Vinyl sheath

Conductor
S = 2.5 mm

φ

 = 2.01 mm

2

Armor

(sectional view)

 

Cable entrance for signal cable
(The connector side which EMI core is attached
should be connected to the processor unit.)

Cable entrance for power cable