Furuno FR-2125V Manual De Usuario

Sweep timing differs with respect to the length of the signal cable between the
antenna unit and the display unit. Adjust sweep timing at installation to prevent
the following symptoms:

•

The echo of a "straight" target (for example, pier), on the 0.25 nm range, will
appear on the display as being pulled inward or pushed outward. See Figure
3-3.

•

The range of target echoes will also be incorrectly shown.

(1) Correct

(2) Target pushed
inward

(3) Target pushed
outward

Figure 3-3 Examples of correct and incorrect sweep timings

1. Press [RADAR MENU] [0] [0] [0] [2] [3] to select TIMING ADJ on the INITIAL

SETTING1 menu.

2. Transmit on the 0.25 nm range.

3. Adjust radar picture controls to display picture properly.

4. Select a target echo which should be displayed straightly.

5. Adjust the VRM control to straighten the target echo.

6. Press the [ENTER] key.

If main bang appears at the screen center, suppress it as follows.

1. Transmit on a long range about ten minutes.

2. Adjust the [GAIN] control to show a slight amount of noise on the display.

3. Select the 0.25 nm range. Adjust the [A/C SEA] control to suppress sea clut-

ter.

4. Press [RADAR MENU] [0] [0] [0] [2] to open the INITIAL SETTING1 menu.

5. Press the [7] key to select 7. MBS.

6. Adjust the VRM control to adjust timing; the EBL control to adjust level.

7. Press the [ENTER] key.