Oregon Scientific WMR80A Manual De Usuario

4

1. Funnel
2. Indicator

1.  LED status indicator
2.  RESET hole
3.  °C / °F: Select temperature unit
4.  CHANNEL switch
5.  Battery compartment

The wind sensor takes wind speed and direction 
readings.  

The sensor is battery operated. It is capable of transmitting 
data to the base station wirelessly within an approximate 
operating range of 100 meters (328 feet). 

 IMPORTANT  Ensure that the wind sensor is pointing 
North to enable it to record accurate readings.

 NOTE  The sensor should be positioned in an open area 
away from trees or other obstructions. 

1.  Unscrew the anemometer from the wind sensor 

carefully.

2.  Insert batteries matching the polarities (+ / -) and 

replace the anemometer.  Press RESET after each 
battery change.

3.   Secure the sensor connector in the desired location:

a.  Align the back of the sensor connector to an 

existing pole.  Secure in place by inserting the ends 
of the U-bolt into the holes on the sensor connector 
and securing it with washers and bolts.

OR
b.   Insert 4 type A screws into the holes of the sensor 

connector. Screw firmly into place, i.e., fence.

4.   Slide wind vane onto the smaller end of the sensor 

connector.

 NOTE   Use alkaline batteries for longer usage and 
consumer grade lithium batteries in temperatures below 
freezing.

The remote sensor can collect data from up to 3 channels.
To set up the remote sensor:
1.  Slide open the battery door.
2.   Slide  channel  switch  to  select  a  channel  (1,  2,  3). 

Ensure you use a different channel for each sensor.

3.   Insert the batteries, matching the polarities (+ / -).
4.   Press RESET after each battery change.
5.   Close the battery door.
 NOTE  Install batteries in the remote sensor before the 
base station matching the polarities (+ and -).
6.  Initiate a sensor search on the base station to start 

receiving temperature / humidity data from the sensor.

1

5

2

3

4

C

F

３a

３b