Furuno tztl15f Manual De Usuario

1.  SYSTEM INTRODUCTION

This equipment uses two types of micro SD cards, chart and data. The chart cards 
contain charts and the data micro SD card stores plotter-related data such as tracks, 
routes, points and generic data such as menu settings. Set and remove the card as 
shown below. The Secure Digital Extended Capacity (SDXC) cards can also be used.

Before inserting a chart card in the multi function display, turn off the power.

You do not normally need to format a data micro SD card. If the card becomes unread-
able, format the card with a formatting program that is compatible with the specifica-
tions of the card.

1) Open the card drive cover.
2) Push the card to release the card from the card drive.
3) Remove the card with your fingers then close the lid (cover).

•  Handle the cards carefully. Improper use can damage the card and 

destroy its contents.

•  Make sure the slot lid (cover) is closed at all times.
•  Remove a card with only your fingers. Do not use metal instruments 

(like tweezers) to remove the card.

•  Do not remove a card during the reading of or writing to the card.

Note: Use a micro SD card class 6 or higher for storing chart data.

Unfasten two 
screws.

Push card into slot 
and close cover.

Open cover.

Push card 
into slot* 
and close 
cover.

* Right slot is for data card; left slot is for chart 
card.