Panasonic SA-XR58 Manual De Usuario
ENGLISH
RQTV0156
38
Specifications (DIN 45 500)
AMPLIFIER SECTION
Power output (at AC 230 to 240 V)
DIN 1 kHz (T.H.D. 1 %)
2 x 100 W (6
Ω)
20 Hz to 20 kHz continuous power output
both channel driven
2 x 80 W (6
Ω)
Total harmonic distortion
rated power at 20 Hz to 20 kHz
0.09 % (6
Ω)
Power bandwidth
both channel driven, -3 dB
4 Hz to 88 kHz (6
Ω, 0.9 %)
Power output each channel driven (at AC 230 to 240 V)
DIN 1 kHz (T.H.D. 1 %)
Front (L/R)
100 W (6
Ω)
Center
100 W (6
Ω)
Surround (L/R)
100 W (6
Ω)
Surround Back (L/R)
100 W (6
Ω)
Load impedance
Front (L/R)
A or B
6
Ω to 16 Ω
A and B
6
Ω to 16 Ω
BI-WIRE
6
Ω to 16 Ω
Center
6
Ω to 16 Ω
Surround (L/R)
6
Ω to 16 Ω
Surround Back (L/R)
6
Ω to 16 Ω
Frequency response
CD, DVD, DVD Recorder, VCR, TV/STB, AUX
4 Hz to 88 kHz, ±3 dB
DVD 6CH
4 Hz to 44 kHz, ±3 dB
Input sensitivity and impedance
CD, DVD/DVD 6CH, DVD Recorder, VCR, TV/STB, AUX
200 mV/22 k
Ω
S/N at rated power (6
Ω)
CD, TV/STB, DVD, DVD Recorder (Digital input)
90 dB (IHF, A: 103 dB)
Tone controls
BASS
50 Hz, +10 dB to -10 dB
TREBLE
20 kHz, +10 dB to -10 dB
Channel balance (250 Hz to 6.3 kHz)
±1 dB
Channel separation
55 dB
Subwoofer frequency response (-6 dB)
7 Hz to 200 Hz
FM TUNER SECTION
Frequency range
87.50 MHz to 108.00 MHz
Sensitivity
S/N 30 dB
1.5 µV/75
Ω
S/N 26 dB
1.3 µV/75
Ω
S/N 20 dB
1.2 µV/75
Ω
IHF usable sensitivity (IHF ’58)
1.5 µV/75
Ω
IHF 46 dB stereo quieting sensitivity
22 µV/75
Ω
Total harmonic distortion
MONO
0.2 %
STEREO
0.3 %
S/N
MONO
60 dB
STEREO
58 dB
Frequency response
20 Hz to 15 kHz, +1 dB, -2 dB
Alternate channel selectivity
±400 kHz, 65 dB
Capture ratio
1.5 dB
Image rejection at 98 MHz
40 dB
IF rejection at 98 MHz
70 dB
Spurious response rejection at 98 MHz
70 dB
AM suppression
50 dB
Stereo separation
40 dB
Carrier leak
19 kHz, -30 dB
38 kHz, -50 dB
Channel balance (250 Hz to 6.3 kHz)
±1.5 dB
Limiting point
1.2 µV
Bandwidth
IF amplifier
180 kHz
FM demodulator
1000 kHz
Antenna terminal
75
Ω (unbalanced)
AM TUNER SECTION
Frequency range
522 kHz to 1611 kHz (9 kHz steps)
530 kHz to 1620 kHz (10 kHz steps)
Sensitivity
20 µV, 330 µV/m
Selectivity (at 999 kHz)
55 dB
IF rejection (at 999 kHz)
50 dB
VIDEO SECTION
Output voltage at 1 V input (unbalanced)
1± 0.1 Vp-p
Maximum input voltage
1.5 Vp-p
Input/output impedance
75
Ω (unbalanced)
S-Video
Input
DVD, DVD Recorder, TV/STB
Output
TV MONITOR
Component Video
Input
DVD Recorder, TV/STB
Output
TV MONITOR
GENERAL
Power supply
AC 230 to 240 V, 50 Hz
Power consumption
140 W
Dimensions (W x H x D)
430 mm x 107.5 mm x 390 mm
Mass
4.7 k
g
Notes:
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Total harmonic distortion is measured by the digital spectrum
analyzer.
1.
2.
3.
Digital input
(OPTICAL)
2
(COAXIAL)
2
HDMI (Version 1.2a) Input
1
Output
1
Power consumption in standby mode:
0.9 W
Power consumption in HDMI off mode:
0.35 W
Help messages
Message
Causes and solutions
Muting is on.
Press [MUTING] on the remote control to cancel (
➡
page 31).
You are trying to use a feature that is available only in
“MUSIC” mode.
Change the mode to
“MUSIC” (
➡
pages 22 to 23).
Center and surround speakers are not connected, or they are set as absent.
Connect the speakers (
➡
page 13) or change their setting to present (
➡
page 27).
Surround and surround back speakers are not connected, or they are set as
absent. Connect the speakers (
➡
page 13) or change their setting to present
(
➡
page 27).
Surround back speakers are not connected, or they are set as absent. Connect
the speakers (
➡
page 13) or change their setting to present (
➡
page 27).
You are trying to use an effect unavailable with DTS-ES sources.
You are trying to use an effect unavailable with DVD-Audio sources.
You are trying to use an effect unavailable with DVD analogue 6-channel input.
You are trying to use an effect unavailable with the current input source.
You are trying to use an effect unavailable with DVD-Audio sources.
You are trying to use an effect unavailable with DVD analogue 6-channel input.
You are trying to use an effect unavailable with the current input source.
(flashing)
You have set the
“PCM FIX” mode. Cancel this mode (
➡
page 28).
SPEAKERS A is off. Press [SPEAKERS A] to turn on
“SPEAKERS A” (
➡
page
18).
SPEAKERS A and SPEAKERS B are off. Select one of the speakers (
SPEAKERS A and SPEAKERS B are off. Select one of the speakers (
➡
page
18).
Specifications/Help messages
SA-XR58.indb 38
6/27/2006 6:55:48 PM