Pioneer SC-35 Manual De Usuario

En

• The distance to the subwoofer may be slightly larger 

than the distance actually measured with a tape 
measure, etc. This is because this distance is 
corrected for electric delay, and is not a problem.

Position of front speakers and monitor
The front speakers should be as equidistant as possible 
to the monitor.

Position of center speaker and monitor
Since mostly dialogs are output from the center speaker, 
keeping the center speaker as close as possible to the 
screen makes the overall sound more natural. For TVs 
using Braun tubes, however, when installing the center 
speaker on the floor, adjust its angle of elevation to point 
it towards the listening position.

• If  the  center speaker is not of the shielded type, install 

it away from the TV.

• When installing the center speaker on top of the 

monitor, place it facing slightly downwards towards 
the listening position.

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with 
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other 
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks 
listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.

• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug 

from the outlet and insert again to return to normal operating conditions.

TV

L

R

45° to 60°

Installation on floor

(Diagram as seen 

from the side)

Monitor

The power does not turn on.

• Make sure that the power cord is plugged in to an active power outlet.
• Try disconnecting from the power outlet, then plugging back in.
SC-37 only:
• When remote control operation is set to RF two-way communications, the receiver’s power cannot 
be turned on unless RF Remote Setup is set to ON (see RF Remote Setup (SC-37 only) on page 120).
• When remote control operation is set to RF two-way communications, check whether the RF 
adapter is properly connected to the receiver.

Power cannot be turned off.
(ZONE 2 ON or ZONE 3 ON is 
displayed.)

• Set the remote control’s MULTI-ZONE operation selector switch to ZONE 2 or ZONE 3, then press 
 RECEIVER to switch the sub zone off.

The receiver suddenly switches 
off or the iPod iPhone 
indicator blinks.

• Check that there are no loose strands of speaker wire touching the rear panel or another set of 
wires. If so, re-attach the speaker wires, making sure there are no stray strands.
• The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized 
independent service company.

SC-37_35_UXJCB.book  122 ページ  ２０１０年３月９日　火曜日　午前９時３２分