Pioneer SC-35 Manual De Usuario
Controlling the rest of your system (In case of SC-37)
10
91
En
Using the RF communications function
With this receiver, two-way communications between the
receiver and remote control are possible by connecting
the included RF adapter to the RS-232C and CU-RF100
terminals. For instructions on connecting the RF adapter,
see Connecting the RF adapter (SC-37 only) on page 21.
Two-way communications allow you to use the following
functions:
receiver and remote control are possible by connecting
the included RF adapter to the RS-232C and CU-RF100
terminals. For instructions on connecting the RF adapter,
see Connecting the RF adapter (SC-37 only) on page 21.
Two-way communications allow you to use the following
functions:
• The receiver can be operated by pointing the remote
control in any direction (360°) (maximum line-of-sight
distance for two-way communications: about 10
meters).
distance for two-way communications: about 10
meters).
• Operate is possible without being affected by
obstacles (even products in racks can be operated).
• The information shown on the receiver’s display can
be displayed on the remote control’s display as you
operate.
operate.
• RF communications can be used to operate up to 4
other components connected to the receiver (using
the included IR blaster. For details, see Operating
other components by RF communications on
page 92).
the included IR blaster. For details, see Operating
other components by RF communications on
page 92).
• The remote control input display names can be
synchronized with the input names changed at Input
Name on the receiver’s Input Setup menu (page 45)
and acquired automatically. For details, see
Renaming input function names in synchrony with
the receiver on page 93.
Name on the receiver’s Input Setup menu (page 45)
and acquired automatically. For details, see
Renaming input function names in synchrony with
the receiver on page 93.
• When the receiver’s input is switched, the remote
control’s display and operating mode switch to that
input automatically. For details, see Setting the
remote control operation mode on page 94.
input automatically. For details, see Setting the
remote control operation mode on page 94.
Important
• The line-of-sight communications distance is a rough
indication, and may differ according to the
surrounding environment.
surrounding environment.
• Depending on the communications environment,
functions using two-way communications between
the receiver and remote control may not operate
properly. For details, including cautions on the
communications environment and usage procedure,
etc., see Precautions when using the Omni-
Directional RF Remote Control on page 94.
the receiver and remote control may not operate
properly. For details, including cautions on the
communications environment and usage procedure,
etc., see Precautions when using the Omni-
Directional RF Remote Control on page 94.
Note
• You can cancel or exit any of the steps by press and
hold MULTI OPERATION for a couple of seconds. To
go back a step, press RETURN.
go back a step, press RETURN.
CONTROL
IN
OUT
RS-232C
Y
ANTENNA
FM UNBAL 75
AM LOOP
P
R
P
B
CU-RF100
IR
IN
IN
OUT
1
2
(OUTPUT 5 V
150 mA MAX)
150 mA MAX)
Remote control operation
IR blaster (only required when you want to
operate other components by RF two-way
communications) (max. 4 components)
operate other components by RF two-way
communications) (max. 4 components)
Operation is possible in any direction the
remote control is pointed (360°)
remote control is pointed (360°)
RF Adapter
Receiver
Operation of the receiver or other
components placed in a rack is possible
components placed in a rack is possible
SC-37_35_UXJCB.book 91 ページ ２０１０年３月９日 火曜日 午前９時３２分