Pioneer SC-35 Manual De Usuario

En

• This section includes explanations for the SC-35’s 

remote control. For instructions for the SC-37’s 
remote control, see Controlling the rest of your 
system (In case of SC-37) on page 83.

The Remote Setup mode is set by pressing the number 
button while pressing R.SETUP. The different items on 
the Remote Setup menu are described below. For their 
setting procedures, refer to the explanations for the 
respective items.

• You can cancel or exit any of the steps by pressing 

R.SETUP.

• After one minute of inactivity, the remote 

automatically exits the operation.

Up to four receivers can be operated discretely using this 
receiver's remote control when using multiple receivers, 
provided they are of the same model as this receiver. The 
receiver to be operated is switched by inputting the 
preset code to set the remote control setting.

• Set the remote modes on the receivers before using 

this function (see Remote Control Mode Setup on 
page 119).

seconds.
The LED flashes continuously.

• To cancel the preset setup mode press R.SETUP.

1” to “Receiver 4”) you wish to operate.
For example, to operate “Receiver 2”, press “2”.

If the LED lights for one second, the setting has been 
successfully completed.

When the preset code is input, the LED flashes three 
times to indicate that the setting has failed.

Preset codes can be set for the various input 
functions. The remote control codes of a number 
of other devices (including products of other 
brands) are preset in the remote control to allow 
these devices to be operated. See “Selecting 
preset codes directly” on page 97.

If the desired operations cannot be performed 
even though you have set the preset codes, the 
remote control signals of other devices can be 
learned directly. See “Programming signals from 
other remote controls” on page 97.

A series of the remote control operations for 
starting listening or viewing can be programmed. 
Multiple remote control codes can be set for the 
different input functions. See “Multi operation and 
System off” on page 99.

System off This is a function for automatically turning off the 

power of devices connected to the receiver. 
Multiple remote control codes can be set, as 
desired. See “Multi operation and System off” on 
page 99.

This is a setting for changing only the remote 
control unit’s operation screen, without changing 
the receiver’s input, when the remote control 
unit’s input function buttons are pressed. This is 
convenient for using the remote control unit for 
devices not connected to the receiver. See “Direct 
function” on page 98.

This function is used to erase remote control 
codes that have been learned. Codes learned for 
the different input functions can be erased 
individually. See “Erasing one of the remote 
control button settings” on page 98.

The backlight lighting pattern can be selected 
from among four modes, in consideration of 
convenience and battery service life. See “Setting 
the backlight mode” on page 99.

This is a function for resetting preset codes that 
have been set. Key resetting can be done for 
individual input functions. See “Erasing all learnt 
settings that are in one input function” on page 98.

This is a function for resetting all remote control 
unit settings you have made to the defaults set 
upon shipment from the factory. See “Resetting 
the remote control settings” on page 101.

Change RC 
mode 

If you have multiple Pioneer receivers, amplifiers, 
etc., this setting can be used to prevent other units 
from operating simultaneously when the remote 
control unit is operated. See “Operating multiple 
receivers” on page 96.

SC-37_35_UXJCB.book  96 ページ  ２０１０年３月９日　火曜日　午前９時３２分