John Deere SB1280 Manual De Usuario

OM 0391SB1274-A 

15 

5:  Insert the rotation bushing 

(item 

1) in the snowblower's welded 

retaining plate. Place the chute (item 2) on 
the plate of the snowblower head and push 
the chute towards the front to insert it in the 
rotation bushing.   

7. Figure 6: Install the retaining plate (item 2) 

on the snowblower by bending each 
bushing end (item 1) inside the retaining 
plate. Align the vertical holes of the retaining 
plate (item 2) with the oblong holes of the 
snowblower. Secure in place with the two 
5/8" x 1 1/2" bolts (item 3) and 5/8" serrated 
flange nuts (item 4) previously removed.  Do 
not tighten. 

6: Insert two 1/2" x 3 1/4" bolts 

(item 5) to join together the two retaining 
plates. Bring the two retaining plates closer.  
When enough threads of the 1/2" x 3 1/4" 
bolts (item 5) exceed the holes, screw in the 
5/8" x 1 1/2" bolts (item 3) slightly.  When 
the bolt ends (item 5) exceed sufficiently, 
secure with two 1/2" nylon insert nuts (item 
6) until the two retaining plates are 
approximately 1/4" apart. 

6:  Tighten the 1/2" x 3 1/4" bolts 

(item 5) to reduce the gap between the 
retaining plates until chute turns with a slight 
resistance. 

10. Figure 6: Tighten the two 5/8" x 1 1/2" bolts 

(item 

3) according to the "Torque 

Specification Table" at the end of the 
manual.