John Deere SB1280 Manual De Usuario
ASSEMBLY
OM 0391SB1274-A
18
CATEGORY 2
(Figure 9)
1. Attach the lower hitches (item 1) by inserting
the Ø1 1/8" Cat. 2 pins (item 2) in the lower
holes of the lower hitches as shown and
secure with the 7/16" linchpins (item 3).
holes of the lower hitches as shown and
secure with the 7/16" linchpins (item 3).
2. Attach the upper hitch (item 4) between the
upper plates (item 6) with the 6 1/16" lg. cat.
2 pin and a 7/16" linchpin (item 5).
2 pin and a 7/16" linchpin (item 5).
3. Level the snowblower with the upper hitch
(item 4) so that it runs parallel to the ground.
4. Set the tractor anti-sway turnbuckles so the
snowblower does not sway. Be sure the
turnbuckles clear the tractor tires.
turnbuckles clear the tractor tires.
IMPORTANT: Before connecting the
snowblower driveline to the tractor drive
shaft, make sure the driveline is not too long
in raised, lowered or middle position. If the
driveline is too long it must be shortened, to
avoid damaged to the tractor. See procedure
on pages 20 to 22.
snowblower driveline to the tractor drive
shaft, make sure the driveline is not too long
in raised, lowered or middle position. If the
driveline is too long it must be shortened, to
avoid damaged to the tractor. See procedure
on pages 20 to 22.
Figure 9