Furuno GP-1610CF Manual De Usuario

This section should be done with the boat in water.

1. Turn on the power and press the MENU key.

2. Press the [0] key.

3. Press the [5] key to select SENSOR SETUP.

SENSOR SETUP

SPD SENSOR

TEMP SENSOR

SPD CALIB

TEMP CALIB

DEPTH CALIB

        : Cursor                                            : +/-

ESC : Esc

STW        

SOG

OWN       NMEA

-00%(-50~+50)

+000

°

C

+0.0m

4. Select source of ship's speed; STW (Speed-Through-Water):

local sensor, SOG (Speed-Over-Ground): GPS.

5. Press ▲ twice to select SPD CALIB.

6. If speed reading is higher or lower than actual speed you may

apply an offset to compensate for this. Enter offset with plus or
minus sign. The 

 key alternately displays plus and minus.

7. If a water temperature sensor is installed, press ▼ to select

TEMP SENSOR.

8. Press t to select OWN. (NMEA is for water temperature data

from external source.)

9. Press ▼ twice to select TEMP CALIB.

10. If temperature reading is higher or lower than actual tempera-

ture you may apply an offset to compensate for this. Enter off-
set with plus or minus sign. The 

 key alternately displays

plus and minus.

11. Press ▼ to select DEPTH CALIB.

12. Enter ship's draft, if applicable. Normally, depth is measured

from the transducer so enter positive figure.

13. Press the MENU key.

1. Press the MENU key.

2. Press the [0] key.

3. Press the [6] key.