Humminbird 4089901 Manual De Usuario
75
Map Datum
(Advanced)
Settings: Various, Default = WGS 84
Map Datum allows you to change the map coordinate system used by the
Fishfinder to match those of a paper map.
Fishfinder to match those of a paper map.
Set Simulation Position
(Advanced)
Settings: Follow screen instructions to activate.
Set Simulation Position allows you to set the position of the boat used in the
Simulator. Press any arrow on the 4-WAY Cursor Control key to activate the
cursor and move it to the coordinates where you want start the simulation.
Then confirm the position using the Set Simulation menu setting.
Simulator. Press any arrow on the 4-WAY Cursor Control key to activate the
cursor and move it to the coordinates where you want start the simulation.
Then confirm the position using the Set Simulation menu setting.
NOTE: The cursor must be active in order for this procedure to work. If the cursor was
not active before you began this procedure, an error message will appear. Exit the
menu, set the cursor, then try again.
not active before you began this procedure, an error message will appear. Exit the
menu, set the cursor, then try again.
Set Map Offset
(Advanced)
Settings: Follow screen instructions to activate.
Set Map Offset allows you to change the map offset used by your Fishfinder.
Press the 4-WAY Cursor Control key to activate the cursor and move it to the
location where the Map Offset will be applied. Then, confirm the map offset
position using the Set Map Offset menu setting.
Press the 4-WAY Cursor Control key to activate the cursor and move it to the
location where the Map Offset will be applied. Then, confirm the map offset
position using the Set Map Offset menu setting.
The Map Offset will be applied to all maps and not just the map that requires
the correction. The Map Offset should be cleared if a different map is to be used.
the correction. The Map Offset should be cleared if a different map is to be used.
NOTE: The cursor must be active in order for this procedure to work. If the cursor was
not active before you began this procedure, an error message will appear. Exit the
menu, set the cursor, then try again.
not active before you began this procedure, an error message will appear. Exit the
menu, set the cursor, then try again.
Navigation Menu Tab