ACR Electronics Y1-03-0240A Manual De Usuario
Y1-03-0240A
13
2.
Manual release bracket
Manual release brackets are designed to hold the beacon securely in place.
The beacon must be manually deployed. The bracket can be mounted on a
vertical flat surface with beacon antenna up or on a horizontal flat surface
facing skyward. This location must be easily accessible in order to manually
deploy the beacon or to perform the required maintenance and functionality
tests. Typical locations include near the helm station or just inside the
companionway door.
The manual release bracket has four pre-drilled screw holes to use for
securing the bracket to a flat surface. Remove the beacon from the bracket.
To do this while holding the assembly, lift the latch to release bracket
pressure from the beacon. The beacon will slide up and out of the bracket.
On either side of the bracket are release tabs. Simultaneously depress each
tab to separate the bracket from the mounting block. The mounting block can
be held in place to mark the placement of the screw holes or you can use the
mounting template provided. The use of #8 pan head stainless steel
fasteners and washers (not included) is recommended. Be sure to confirm
that fasteners will not contact any wires or plumbing before drilling pilot holes.
The beacon must be manually deployed. The bracket can be mounted on a
vertical flat surface with beacon antenna up or on a horizontal flat surface
facing skyward. This location must be easily accessible in order to manually
deploy the beacon or to perform the required maintenance and functionality
tests. Typical locations include near the helm station or just inside the
companionway door.
The manual release bracket has four pre-drilled screw holes to use for
securing the bracket to a flat surface. Remove the beacon from the bracket.
To do this while holding the assembly, lift the latch to release bracket
pressure from the beacon. The beacon will slide up and out of the bracket.
On either side of the bracket are release tabs. Simultaneously depress each
tab to separate the bracket from the mounting block. The mounting block can
be held in place to mark the placement of the screw holes or you can use the
mounting template provided. The use of #8 pan head stainless steel
fasteners and washers (not included) is recommended. Be sure to confirm
that fasteners will not contact any wires or plumbing before drilling pilot holes.
LATCH OPEN
LATCH
CLOSED
CLOSED
Mounted to wall