Polycom 40/0 Manual De Usuario

 

System Configuration

Polycom, Inc. 

29

If your network supports SIP, you can use SIP to connect video calls. RealPresence Capture Server 
supports SIP integration with SIP servers such as the Polycom DMA.

1 Go to Configuration > Signaling Settings > SIP.
2 Configure the following settings:

System H.323 Alias

Specify the H.323 alias for the system.

Remote Display Name

Specify the name to be displayed to the far end.
Note: If you set the remote display name with dual-bytes characters like 
Chinese, you will not see the characters on the far end endpoints in a 
H.323 call between endpoints and the Capture Server system.

If the RealPresence Capture Server is registered to DMA as gatekeeper, you can 
find Capture Server's information on DMA portal under Network > MCU > MCUs.

Transport Type

Specify the transport layer protocol used for communicating with the SIP 
server. It needs to be consistent with the protocol supported by the SIP 
server.

Enable Certificate Validation

Specify whether to validate the server’s certificate before accepting it.
This option is available only after you select TLS as the Transport Type.
Note: RealPresence Capture Server always sends its own certificate to the 
server, regardless of the selection here.

Register to SIP Server

Specify whether to register the system to the SIP server.

SIP Server Type

Choose a SIP server type from the dropdown list, currently only Generic 
available.

SIP Server status

Specify:
•

Note: Never enter Capture Server IP for Server Address.

Register User’s Information

Specify:
•